3com S7906E 설치 설명서
1-11
The configuration of IGP shortcut and forwarding adjacency is broken down into tunnel configuration
and IGP configuration. When making tunnel configuration on a TE tunnel interface, consider the
following:
and IGP configuration. When making tunnel configuration on a TE tunnel interface, consider the
following:
z
The tunnel destination address should be in the same area where the tunnel interface is located.
z
The tunnel destination address should be reachable through intra-area routing.
CR-LSP Backup
CR-LSP backup provides end-to-end path protection for the entire LSP without time limitation. This is
different from Fast Reroute (FRR) which provides quick but temporary per-link or per-node protection
on an LSP.
different from Fast Reroute (FRR) which provides quick but temporary per-link or per-node protection
on an LSP.
In the same TE tunnel, the LSP used to back up a primary LSP is called a secondary LSP. When the
ingress of a TE tunnel detects that the primary LSP is unavailable, it switches traffic to the secondary
LSP and after the primary LSP becomes available, switches traffic back. This is how LSP path
protection is achieved.
ingress of a TE tunnel detects that the primary LSP is unavailable, it switches traffic to the secondary
LSP and after the primary LSP becomes available, switches traffic back. This is how LSP path
protection is achieved.
Two approaches are available for CR-LSP backup:
z
Hot backup where a secondary CR-LSP is created immediately after a primary CR-LSP is created.
MPLS TE switches traffic to the secondary CR-LSP after the primary CR-LSP fails.
MPLS TE switches traffic to the secondary CR-LSP after the primary CR-LSP fails.
z
Standard backup where a secondary CR-LSP is created to take over after the primary CR-LSP
fails.
fails.
Fast Reroute
This section covers these topics:
z
z
z
z
Overview
Fast Reroute (FRR) provides a quick per-link or per-node protection on an LSP.
In this approach, once a link or node fails on a path, FRR comes up to reroute the path to a new link or
node to bypass the failed link or node. This can happen as fast as 50 milliseconds thus minimizing data
loss.
node to bypass the failed link or node. This can happen as fast as 50 milliseconds thus minimizing data
loss.
Once a link or node on an LSP configured with FRR fails, traffic is switched to the protection link and the
headend of the LSP starts attempting to set up a new LSP.
headend of the LSP starts attempting to set up a new LSP.
Basic concepts
The following are concepts that FRR involves throughout this document:
z
Primary LSP: The protected LSP.
z
Bypass LSP: An LSP used to protect the primary LSP.
z
Point of local repair (PLR): The ingress of the bypass LSP. It must be located on the primary LSP
but must not be the egress.
but must not be the egress.
z
Merge point (MP): The egress of the bypass LSP. It must be located on the primary LSP but must
not be the ingress.
not be the ingress.