3com S7906E 설치 설명서

 

1-9 

For introduction to Graceful Restart (GR), refer to GR Overview in the High Availability Volume. 

 

The RSVP-TE GR function depends on the extended hello capability of RSVP-TE. A GR-capable 
device advertises its GR capability and relevant time parameters to its neighbors by extended RSVP 
Hello packets. If a device and all its neighbors have the RSVP GR capability and have exchanged GR 
parameters, each of them can function as the GR helper of another device, allowing data to be 
forwarded without interruption when the GR restarter is rebooting. 

A GR helper considers that a GR restarter is rebooting when it receives no Hello packets from the 
restarter in a specified period of time. When a GR restarter is rebooting, the GR helpers retain soft state 
information about the GR restarter and keep sending Hello packets periodically to the GR restarter until 
the restart timer expires. 

If a GR helper and the GR restarter reestablish a Hello session before the restart timer expires, the 
recovery timer is started and signaling packet exchanging is triggered to restore the original soft state. 
Otherwise, all RSVP soft state information and forwarding entries relevant to the neighbor will be 
removed. If the recovery timer expires, soft state information and forwarding entries that are not 
restored during the GR restarting process will be removed. 

 

S7900E series, can act as a GR restarter and a GR helper at the same time. 

Even when an MPLS TE tunnel is available, traffic is IP routed if you do not configure it to travel the 
tunnel. For traffic to be routed along an MPLS TE tunnel, you can use static routing, policy routing, or 
automatic route advertisement.  

Static routing is the easiest way to route traffic along an MPLS TE tunnel. You only need to manually 
create a route that reaches the destination through the tunnel interface.  

 

For more information about static routing, refer to the Static Routing Configuration in the IP Routing 

.