3com S7906E 설치 설명서

 

1-6 

Enter 
Ethernet 
interface 
view 

interface interface-type 
interface-number 

Enter 
Layer-2 
aggregate 
interface 
view 

interface 
bridge-aggregation 
interface-number 

Enter 
Ethernet 
interface 
view or 
port-group 
view 

Enter 
port-group 
view 

port-group manual 
port-group-name 

Required 

Use either command. 

z 

In Ethernet interface view, the 
subsequent configurations apply 
to the current port. 

z 

In port group view, the 
subsequent configurations apply 
to all ports in the port group. 

z 

In Layer-2 aggregate interface 
view, the subsequent 
configurations apply to the 
Layer-2 aggregate interface and 
all its member ports. 

Configure the hold timer, 
join timer, and leave timer  

garp timer { hold | join | 
leave } timer-value 

Optional 

The default is 10 centiseconds for the 
hold timer, 20 centiseconds for the 
join timer, and 60 centiseconds for 
the leave timer. 

 

When configuring GARP timers, note that their values are dependent on each other and must be a 

multiple of five centiseconds. If the value range for a timer is not desired, you may change it by tuning 

the value of another related timer as shown in the following table: 

Table 1-2 Dependencies of GARP timers 

Hold 

10 centiseconds 

Not greater than half of the join 
timer setting  

Join 

Not less than two times the hold timer setting 

Less than half of the leave timer 
setting  

Leave 

Greater than two times the join timer setting  

Less than the LeaveAll timer 
setting  

LeaveAll 

Greater than the leave timer setting  

32765 centiseconds 

 

The GVRP configuration made on a link aggregation member port can take effect only after the port is 

removed from the group. For more information about link aggregation, refer to Link Aggregation 

Configuration in the Access Volume. 

 

Display statistics about GARP  

display garp statistics [ interface 
interface-list ] 

Available in any view