3com S7906E 安装指导
1-6
To do…
Use the command…
Remarks
Enter
Ethernet
interface
view
Ethernet
interface
view
interface interface-type
interface-number
interface-number
Enter
Layer-2
aggregate
interface
view
Layer-2
aggregate
interface
view
interface
bridge-aggregation
interface-number
bridge-aggregation
interface-number
Enter
Ethernet
interface
view or
port-group
view
Ethernet
interface
view or
port-group
view
Enter
port-group
view
port-group
view
port-group manual
port-group-name
port-group-name
Required
Use either command.
z
In Ethernet interface view, the
subsequent configurations apply
to the current port.
subsequent configurations apply
to the current port.
z
In port group view, the
subsequent configurations apply
to all ports in the port group.
subsequent configurations apply
to all ports in the port group.
z
In Layer-2 aggregate interface
view, the subsequent
configurations apply to the
Layer-2 aggregate interface and
all its member ports.
view, the subsequent
configurations apply to the
Layer-2 aggregate interface and
all its member ports.
Configure the hold timer,
join timer, and leave timer
join timer, and leave timer
garp timer { hold | join |
leave } timer-value
leave } timer-value
Optional
The default is 10 centiseconds for the
hold timer, 20 centiseconds for the
join timer, and 60 centiseconds for
the leave timer.
hold timer, 20 centiseconds for the
join timer, and 60 centiseconds for
the leave timer.
When configuring GARP timers, note that their values are dependent on each other and must be a
multiple of five centiseconds. If the value range for a timer is not desired, you may change it by tuning
the value of another related timer as shown in the following table:
Table 1-2 Dependencies of GARP timers
Timer
Lower limit
Upper limit
Hold
10 centiseconds
Not greater than half of the join
timer setting
timer setting
Join
Not less than two times the hold timer setting
Less than half of the leave timer
setting
setting
Leave
Greater than two times the join timer setting
Less than the LeaveAll timer
setting
setting
LeaveAll
Greater than the leave timer setting
32765 centiseconds
The GVRP configuration made on a link aggregation member port can take effect only after the port is
removed from the group. For more information about link aggregation, refer to Link Aggregation
Configuration in the Access Volume.
Displaying and Maintaining GVRP
To do…
Use the command…
Remarks
Display statistics about GARP
display garp statistics [ interface
interface-list ]
interface-list ]
Available in any view