3com S7906E 설치 설명서
1-3
Configuring IPv6 BGP Basic Functions
Prerequisites
Before configuring this task, you need to:
z
Specify IP addresses for interfaces.
z
Enable IPv6.
You need create a peer group before configuring basic functions for it. For related information, refer to
Specifying an IPv6 BGP Peer
Follow these steps to configure an IPv6 BGP peer:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Specify a router ID
router-id router-id
Optional
Required if no IP addresses are
configured for any interfaces.
configured for any interfaces.
Enter IPv6 address family view
ipv6-family
—
Specify an IPv6 peer
peer ipv6-address as-number
as-number
as-number
Required
Injecting a Local IPv6 Route
Follow these steps to configure advertise a local route into the routing table:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—
Inject a local route into the IPv6
BGP routing table
BGP routing table
network ipv6-address
prefix-length [ short-cut |
route-policy
route-policy-name ]
prefix-length [ short-cut |
route-policy
route-policy-name ]
Required
Not added by default
Configuring a Preferred Value for Routes from a Peer/Peer Group
Follow these steps to configure a preferred value for routes received from a peer/peer group: