3com S7906E 참조 가이드

 

1-7 

Referenced route type 

Type of the referenced route, which can be any of the 
following:  

z 

igp: IPv6 unicast route (IGB).  

z 

egp: IPv6 unicast (EGP).  

z 

unicast (direct): IPv6 unicast route (directly 
connected).  

z 

unicast: other IPv6 unicast route (such as IPv6 
unicast static route).  

z 

mbgp: IPv6 MBGP route. 

Route selection rule 

RPF route selection rule: An RPF route can be selected 
by the priority of the routing protocol or by the longest 
match of the destination address in the routing table. 

Load splitting rule 

Load sharing rule 

 

multicast ipv6 boundary ipv6-group-address prefix-length 

undo multicast ipv6 boundary { ipv6-group-address prefix-length | all } 

Interface view 

2: System level 

ipv6-group-address: IPv6 multicast group address, in the range of FFxy::/16, where x and y represent 

any hexadecimal number from 0 through F. 

prefix-length: Prefix length of an IPv6 multicast group address, in the range of 8 to 128. 

all: Deletes all IPv6 multicast boundaries configured on the interface. 

Use the multicast ipv6 boundary command to configure an IPv6 multicast forwarding boundary. 

Use the undo multicast ipv6 boundary command to delete the specified IPv6 multicast forwarding 

boundary or all IPv6 multicast forwarding boundaries. 

By default, no multicast forwarding boundary is configured.  

Note that:  

z 

A multicast forwarding boundary sets the boundary condition for the IPv6 multicast groups in the 

specified range. If the destination address of an IPv6 multicast packet matches the set boundary 

condition, the packet will not be forwarded.  

z 

If an interface needs to act as a forwarding boundary for multiple IPv6 multicast groups, just carry 

out this command on the interface once for each group.  

z 

Assume that Set A and Set B are both multicast forwarding boundary sets to be configured, and 

that B is a subset of A. If A has been configured on an interface, it is not allowed to configure B on