3com S7906E 참조 가이드
1-19
ipv6-source-address: IPv6 address of the specified multicast source.
Description
Use the mld static-group command to configure the current interface to be a statically-connected
member of the specified IPv6 multicast group or IPv6 multicast source and group.
Use the undo mld static-group command to remove the configuration.
By default, an interface is not a statically-connected member of any IPv6 multicast group or IPv6
multicast source and group.
If the IPv6 multicast address is in the SSM multicast address range, you must specify an IPv6 multicast
source address at the same time; otherwise MLD routing table entries cannot be established. There is
no such a restriction if the specified IPv6 multicast group address is not in the SSM multicast address
range.
Examples
# Configure Vlan-interface1 to be a statically-connected member of the IPv6 multicast group FF03::101.
<Sysname> system-view
[Sysname] interface Vlan-interface1
[Sysname-Ethernet1/1] mld static-group ff03::101
# Configure Vlan-interface1 as a static member to forward multicast data of the multicast source
2001::101 to the multicast group FF3E::202.
<Sysname> system-view
[Sysname] interface Vlan-interface1
[Sysname-Vlan-interface1] mld static-group ff3e::202 source 2001::101
mld timer other-querier-present
Syntax
mld timer other-querier-present interval
undo mld timer other-querier-present
View
Interface view
Default Level
2: System level
Parameters
interval: MLD other querier present interval in seconds, in the range of 60 to 300.
Description
Use the mld timer other-querier-present command to configure the MLD other querier present
interval on the current interface.
Use the undo mld timer other-querier-present command to restore the system default.
By default, MLD other querier present interval = [ MLD query interval ] times [ MLD querier robustness
variable ] plus [ maximum response delay for MLD general queries ] divided by two.