Справочное Руководство для 3com S7906E

 

1-19 

ipv6-source-address: IPv6 address of the specified multicast source. 

Use the mld static-group command to configure the current interface to be a statically-connected 

member of the specified IPv6 multicast group or IPv6 multicast source and group. 

Use the undo mld static-group command to remove the configuration. 

By default, an interface is not a statically-connected member of any IPv6 multicast group or IPv6 

multicast source and group. 

If the IPv6 multicast address is in the SSM multicast address range, you must specify an IPv6 multicast 

source address at the same time; otherwise MLD routing table entries cannot be established. There is 

no such a restriction if the specified IPv6 multicast group address is not in the SSM multicast address 

range. 

# Configure Vlan-interface1 to be a statically-connected member of the IPv6 multicast group FF03::101. 

<Sysname> system-view 

[Sysname] interface Vlan-interface1 

[Sysname-Ethernet1/1] mld static-group ff03::101 

# Configure Vlan-interface1 as a static member to forward multicast data of the multicast source 

2001::101 to the multicast group FF3E::202. 

<Sysname> system-view 

[Sysname] interface Vlan-interface1 

[Sysname-Vlan-interface1] mld static-group ff3e::202 source 2001::101 

mld timer other-querier-present interval 

Interface view  

2: System level 

interval: MLD other querier present interval in seconds, in the range of 60 to 300. 

Use the mld timer other-querier-present command to configure the MLD other querier present 

interval on the current interface. 

Use the undo mld timer other-querier-present command to restore the system default. 

By default, MLD other querier present interval = [ MLD query interval ] times [ MLD querier robustness 

variable ] plus [ maximum response delay for MLD general queries ] divided by two.