3com S7906E 참조 가이드

 

1-50 

2: System level 

None 

Use the reflect between-clients command to enable route reflection between clients. 

Use the undo reflect between-clients command to disable the function. 

By default, route reflection between clients is enabled. 

If fully meshed interconnections exist between the clients, route reflection is not required. Otherwise, an 

RR is required for routes to be reflected from one client to every other client. 

# In BGP-VPNv4 subaddress family view, disable route reflection between clients. 

<Sysname> system-view 

[Sysname] bgp 100 

[Sysname-bgp] ipv4-family vpnv4 

[Sysname-bgp-af-vpnv4] undo reflect between-clients 

# In BGP-L2VPN address family view, disable route reflection between clients. 

<Sysname> system-view 

[Sysname] bgp 100 

[Sysname-bgp] l2vpn-family 

[Sysname-bgp-af-l2vpn] undo reflect between-clients 

reflector cluster-id { cluster-id | ip-address } 

undo reflector cluster-id 

BGP-VPNv4 subaddress family view, BGP-L2VPN address family view 

2: System level 

cluster-id: Cluster ID of the route reflector (RR), in the range 1 to 4294967295. 

ip-address: IP address of the peer, which is to be used as the cluster ID of the RR. 

Use the reflector cluster-id command to specify a cluster ID for an RR. 

Use the undo reflector cluster-id command to remove the cluster ID. 

By default, the cluster ID is the router ID of an RR in the cluster.