3com MSR 20-20 참조 매뉴얼
1007
Parameters
None
Description
Use the reflect between-clients command to enable route reflection between
clients.
clients.
Use the undo reflect between-clients command to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to other
clients. If the clients of a route reflector are fully meshed, you need disable route
reflection between clients to reduce routing costs.
clients. If the clients of a route reflector are fully meshed, you need disable route
reflection between clients to reduce routing costs.
Related commands:
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] undo reflect between-clients
reflector cluster-id (BGP view)
Syntax
reflector cluster-id cluster-id
undo reflector cluster-id
View
BGP view
Parameters
cluster-id: Cluster ID of the route reflector, an integer from 1 to 4294967295 (the
integer is translated into an IP address by the system) or an IP address.
integer is translated into an IP address by the system) or an IP address.
Description
Use the reflector cluster-id command to configure the cluster ID of the route
reflector.
reflector.
Use the undo reflector cluster-id command to remove the configured cluster
ID.
ID.
By default, each route reflector uses its router ID as the cluster ID.
Usually, there is only one route reflector in a cluster. The router ID of the route
reflector is the ID of the cluster. You can configure multiple route reflectors to
improve the stability of the network. In this case, using this command can
configure the identical cluster ID for all the route reflectors to avoid routing loops.
reflector is the ID of the cluster. You can configure multiple route reflectors to
improve the stability of the network. In this case, using this command can
configure the identical cluster ID for all the route reflectors to avoid routing loops.
Related commands:
Examples
# Set the cluster ID to 80.