3com MSR 20-20 참조 매뉴얼
1180
C
HAPTER
77: RIP C
ONFIGURATION
C
OMMANDS
undo rip triggered
View
Interface view
Parameters
None
Description
Use the rip triggered command to enable triggered RIP.
Use the undo rip triggered command to disable triggered RIP.
By default, the triggered RIP is disabled.
Note that triggered RIP can only run on link layer protocols PPP, Frame Relay, and
X.25.
X.25.
Examples
# Enable triggered RIP.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] rip triggered
rip version
Syntax
rip version { 1 | 2 [ broadcast | multicast ] }
undo rip version
View
Interface view
Parameters
1: RIP version 1.
2: RIP version 2.
broadcast: Sends RIP-2 messages in broadcast mode.
multicast: Sends RIP-2 messages in multicast mode.
Description
Use the rip version command to specify a RIP version for the interface.
Use the undo rip version command to remove the specified RIP version.
By default, no RIP version is configured for an interface, which uses the global RIP
version. If the global RIP version is not configured, the interface can only send
RIP-1 broadcasts and can receive RIP-1 broadcasts and unicasts, and RIP-2
broadcasts, multicasts and unicasts.
version. If the global RIP version is not configured, the interface can only send
RIP-1 broadcasts and can receive RIP-1 broadcasts and unicasts, and RIP-2
broadcasts, multicasts and unicasts.
If RIP-2 is specified with no sending mode configured, RIP-2 messages will be sent
in multicast mode.
in multicast mode.
When RIP-1 runs on an interface, the interface will: