3com MSR 20-20 참조 매뉴얼

Use the peer reflect-client command to configure the router as a route reflector 
and specify a peer/peer group as a client.

Use the undo peer reflect-client command to remove the configuration.

By default, neither route reflector nor client is configured.

reflect between-clients (IPv6 address family view) and reflector cluster-id 
(IPv6 address family view).

# Configure the local device as a route reflector and specify the peer group test as 
a client.

<Sysname> system-view

[Sysname] bgp 100

[Sysname-bgp] ipv6-family

[Sysname-bgp-af-ipv6] group test

[Sysname-bgp-af-ipv6] peer test reflect-client 

peer { group-name | ipv4-address | ipv6-address } route-limit limit [ percentage ]

undo peer { group-name | ipv4-address | ipv6-address } route-limit

IPv6 address family view

group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.

ipv4-address: IPv4 address of a peer.

ipv6-address: IPv6 address of a peer.

limit: Specifies an upper limit from 1 to 10000 for address prefixes that can be 
received from the peer or peer group

percentage: Specifies the percentage of routes to generate alarm information, 
ranging from 1 to 100, with the default as 75.

Use the peer route-limit command to set the maximum number of prefixes that 
can be received from a peer/peer group.

Use the undo peer route-limit command to restore the default.

By default, the router has no limit on prefixes from a peer/peer group.

The router will end the peer relation when the number of address prefixes received 
for the peer exceeds the limit.

# Set the number of prefixes allowed to receive from the peer 1:2::3:4 to 10000.