3com MSR 20-20 참조 매뉴얼

C

HAPTER

 91: IP

V

6 M

ULTICAST

 R

OUTING

 

AND

 F

ORWARDING

 C

ONFIGURATION

 C

OMMANDS

Use the multicast ipv6 minimum-hoplimit command to configure the 
minimum hop limit required for an IPv6 multicast packet to be forwarded.

Use the undo multicast minimum-hoplimit command to restore the system 
default.

By default, the minimum hop limit required for an IPv6 multicast packet to be 
forwarded is 1.

# Set the minimum hop limit required for an IPv6 multicast packet to be forwarded 
by Ethernet 1/0 to 8.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] multicast ipv6 minimum-hoplimit 8 

System view

None

Use the multicast ipv6 routing-enable command to enable IPv6 multicast 
routing.

Use the undo multicast ipv6 routing-enable command to disable IPv6 
multicast routing.

IPv6 multicast routing is disabled by default.

Note that:

■

You must enable IPv6 multicast routing before you can carry out other Layer 3 
IPv6 multicast commands.

■

The device does not forward any IPv6 multicast packets before IPv6 multicast 
routing is enabled.

# Enable IPv6 multicast routing.

<Sysname> system-view

[Sysname] multicast ipv6 routing-enable