3com MSR 20-20 참조 매뉴얼
1484
C
HAPTER
93: IP
V
6 PIM C
ONFIGURATION
C
OMMANDS
MTU of the network. As a result, the products that do not support
fragmentation will drop the join/prune message.
fragmentation will drop the join/prune message.
■
The (S, G) join/prune state hold time on the upstream device. If you configure a
small queue size, the outgoing interface of the corresponding entry may have
been pruned due to timeout before the last join/prune message in a queue
reaches the upstream device.
small queue size, the outgoing interface of the corresponding entry may have
been pruned due to timeout before the last join/prune message in a queue
reaches the upstream device.
Related commands:
Example
# Configure a join/prune messages to contain a maximum of 2,000 (S, G) entries.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] jp-queue-size 2000
pim ipv6
Syntax
pim ipv6
undo pim ipv6
View
System view
Parameter
None
Description
Use the pim ipv6 command to enter IPv6 PIM view.
Use the undo pim ipv6 command to remove all configurations performed in IPv6
PIM view.
PIM view.
IPv6 multicast must be enabled on the device before this command can take
effect.
effect.
Related command:
Example
# Enable IPv6 multicast routing and enter IPv6 PIM view.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable
[Sysname] pim ipv6
[Sysname-pim6]
pim ipv6 bsr-boundary
Syntax
pim ipv6 bsr-boundary
undo pim ipv6 bsr-boundary