3com MSR 20-20 참조 매뉴얼

C

HAPTER

 93: IP

V

6 PIM C

ONFIGURATION

 C

OMMANDS

Use the pim ipv6 timer hello command to configure on the current interface 
the interval at which hello messages are sent.

Use the undo pim ipv6 timer hello command to restore the default setting.

By default, hello messages are sent at the interval of 30 seconds.

# Set the hello interval to 40 seconds on Ethernet 1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] pim ipv6 timer hello 40 

pim ipv6 timer join-prune interval

Interface view

interval: Join/prune interval in seconds, with an effective range of 1 to 
2,147,483,647.

Use the pim ipv6 timer join-prune command to configure on the current 
interface the interval at which join/prune messages are sent.

Use the undo pim ipv6 timer join-prune command to restore the default 
setting.

By default, the join/prune interval is 60 seconds.

# Set the join/prune interval to 80 seconds on Ethernet 1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] pim ipv6 timer join-prune 80 

pim ipv6 triggered-hello-delay interval

Interface view