3com MSR 20-20 참조 매뉴얼
1560
C
HAPTER
95: MPLS B
ASICS
C
ONFIGURATION
C
OMMANDS
in-label: Incoming label value, in the range 16 to 1,023.
Description
Use the static-lsp egress command to configure a static LSP taking the current
LSR as the egress.
LSR as the egress.
Use the undo static-lsp egress command to remove a static LSP taking the
current LSR as the egress.
current LSR as the egress.
Related command:
Example
# Configure a static LSP named bj-sh, taking the current LSR as the egress.
<Sysname> system-view
[Sysname] static-lsp egress bj-sh incoming-interface serial 2/0 in-label 233
static-lsp ingress
Syntax
static-lsp ingress lsp-name { destination dest-addr { mask | mask-length } }
{ nexthop next-hop-addr | outgoing-interface interface-type interface-number }
out-label out-label
{ nexthop next-hop-addr | outgoing-interface interface-type interface-number }
out-label out-label
undo static-lsp ingress lsp-name
View
System view
Parameter
lsp-name: Name for the LSP, a string of 1 to 15 characters.
dest-addr: Destination IP address of the LSP.
mask: Mask of the destination IP address.
mask-length: Length of the mask for the destination address, in the range 0 to 32.
next-hop-addr: Address of the next hop.
interface-type interface-number: Specifies an interface by its type and number.
out-label: Outgoing label value, in the range 16 to 1023.
Description
Use the static-lsp ingress command to configure a static LSP taking the current
LSR as the ingress.
LSR as the ingress.
Use the undo static-lsp ingress command to remove a static LSP taking the
current LSR as the ingress.
current LSR as the ingress.
Note that:
■
If you specify the next hop when configuring a static LSP, and the address of
the next hop is present in the routing table, you must also specify the next hop
when configuring the static IP route.
the next hop is present in the routing table, you must also specify the next hop
when configuring the static IP route.