3com MSR 20-20 참조 매뉴얼
1692
C
HAPTER
98: MPLS L3VPN C
ONFIGURATION
C
OMMANDS
t
LSP
1
aaa
LSP CR-LSP GRE
1
bbb
LSP
1
# Display tunneling policy aaa.
<Sysname>display tunnel-policy policy-name aaa
Tunnel Policy Name
Select-Seq
Load balance No
------------------------------------------------------
aaa
LSP CR-LSP GRE
1
domain-id
Syntax
domain-id domain-id [ secondary ]
undo domain-id [ domain-id ]
View
OSPF view
Parameter
domain-id: OSPF domain ID, in integer or dotted decimal notation. If it is in
integer, it ranges from 0 to 4,294,967,295.
integer, it ranges from 0 to 4,294,967,295.
secondary: Uses the domain ID as secondary. With this keyword not specified, the
domain ID configured is primary.
domain ID configured is primary.
Description
Use the domain-id command to configure an OSPF domain ID.
Use the undo domain-id command to restore the default.
By default, the OSPF domain ID is 0.
With no parameter specified, the undo domain-id command deletes the primary
domain ID.
domain ID.
Usually, routes injected from PEs are advertised as External-LSAs. However, routes
to different destinations in the same OSPF domain must be advertised as Type-3
LSAs. Therefore, using the same domain ID for an OSPF domain is required.
to different destinations in the same OSPF domain must be advertised as Type-3
LSAs. Therefore, using the same domain ID for an OSPF domain is required.
Example
# Configure the OSPF domain ID.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] domain-id 234
Table 461 Description on the fields of the display tunnel-policy command
Field Description
Tunnel Policy Name
Name of the tunneling policy
Select-Seq
preference order for tunnel selection
Load balance No
Number of tunnels for load balancing