3com MSR 20-20 참조 매뉴얼
180
C
HAPTER
9: C
ONFIGURATION
C
OMMANDS
FOR
E
THERNET
I
NTERFACES
IN
B
RIDGE
M
ODE
loopback-detection enable
Syntax
loopback-detection enable
undo loopback-detection enable
View
System view/Ethernet interface view
Parameter
None
Description
Use the loopback-detection enable command to enable loopback detection
globally or on a specified port.
globally or on a specified port.
Use the undo loopback-detection enable command to disable loopback
detection globally or on a specified port.
detection globally or on a specified port.
By default, loopback detection is disabled for an Access, Trunk, or Hybrid port.
■
If an Access port has been detected with loopback, it will be shutdown. A Trap
message will be sent to the terminal and the corresponding MAC address If a
Trunk port or Hybrid port has been detected with loopback, a Trunk message
will be sent to the terminal. They will be shutdown if the loopback testing
function is enabled on them. In addition, a Trap message will be sent to the
terminal and the corresponding MAC address forwarding entries will be
deleted.
message will be sent to the terminal and the corresponding MAC address If a
Trunk port or Hybrid port has been detected with loopback, a Trunk message
will be sent to the terminal. They will be shutdown if the loopback testing
function is enabled on them. In addition, a Trap message will be sent to the
terminal and the corresponding MAC address forwarding entries will be
deleted.
Related command:
c
CAUTION:
■
Loopback detection on a given port is enabled only after the
loopback-detection enable command has been issued in both system view
and the interface view of the port.
loopback-detection enable command has been issued in both system view
and the interface view of the port.
■
Loopback detection on all ports will be disabled after the issuing of the undo
loopback-detection enable command under system view.
loopback-detection enable command under system view.
Example
# Enable loopback detection on the interface Ethernet 1/0.
<Sysname> system-view
[Sysname] loopback-detection enable
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] loopback-detection enable
loopback-detection interval-time
Syntax
loopback-detection interval-time time
undo loopback-detection interval-time
View
System view