3com MSR 20-20 참조 매뉴얼
198
C
HAPTER
11: F
UNDAMENTAL
S
ERIAL
I
NTERFACE
C
ONFIGURATION
C
OMMANDS
Example
# Set the MTU of interface Serial 2/0 to 1,200 bytes.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial1/0] mtu 1200
physical-mode
Syntax
physical-mode { async | sync }
View
Serial interface view
Parameter
async: Sets the synchronous/asynchronous serial interface to operate in
asynchronous mode.
asynchronous mode.
sync: Sets the synchronous/asynchronous serial interface to operate in
synchronous mode.
synchronous mode.
Description
Use the physical-mode command to set the operating mode of the
synchronous/asynchronous serial interface.
synchronous/asynchronous serial interface.
By default, synchronous/asynchronous serial interfaces are operating in
synchronous mode.
synchronous mode.
Example
# Set synchronous/asynchronous serial interface 2/0 to operate in asynchronous
mode.
mode.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial1/0] physical-mode async
phy-mru
Syntax
phy-mru size
undo phy-mru
View
Asynchronous serial interface view, AUX interface view
Parameter
size: Maximum receive unit (MRU) to be set, in the range 4 to 1,700 (in bytes).
Description
Use the phy-mru command to set the MRU for an asynchronous serial interface
operating in flow mode.
operating in flow mode.
Use the undo phy-mru command to restore the default.
By default, the MRU of an asynchronous serial interface is 1,700 bytes.
Note that these two commands only apply to interfaces operating in the
asynchronous flow mode.
asynchronous flow mode.