3com MSR 20-20 참조 매뉴얼

C

HAPTER

 129: HWTACACS C

ONFIGURATION

 C

OMMANDS

reset stop-accounting-buffer, hwtacacs scheme, display 
stop-accounting-buffer.

# Set the maximum number of stop-accounting request transmission attempts to 
50.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] retry stop-accounting 50 

secondary accounting ip-address [ port-number ]

HWTACACS scheme view

ip-address: IP address of the server, a valid unicast address in dotted decimal 
notation. The default is 0.0.0.0.

port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 
49.

Use the secondary accounting command to specify the secondary HWTACACS 
accounting server.

Use the undo secondary accounting command to remove the configuration.

Note that:

■

The IP addresses of the primary and secondary accounting servers cannot be 
the same. Otherwise, the configuration fails.

■

The HWTACACS service port configured on the device and that of the 
HWTACACS server must be consistent.

■

If you configure the command for more than one time, the last configuration 
takes effect.

■

You can remove an accounting server only when no active TCP connection for 
sending accounting packets is using it.

# Configure the secondary accounting server.

<Sysname> system-view

[Sysname] hwtacacs scheme hwt1

[Sysname-hwtacacs-hwt1] secondary accounting 10.163.155.12 49 

secondary authentication ip-address [ port-number ]