3com MSR 20-20 참조 매뉴얼
1982
C
HAPTER
129: HWTACACS C
ONFIGURATION
C
OMMANDS
primary authorization
Syntax
primary authorization ip-address [ port-number ]
undo primary authorization
View
HWTACACS scheme view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
notation. The default is 0.0.0.0.
notation. The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to
49.
49.
Description
Use the primary authorization command to specify the primary HWTACACS
authorization server.
authorization server.
Use the undo primary authorization command to remove the configuration.
Note that:
■
The IP addresses of the primary and secondary authorization servers cannot be
the same. Otherwise, the configuration fails.
the same. Otherwise, the configuration fails.
■
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
HWTACACS server must be consistent.
■
If you configure the command for more than one time, the last configuration
takes effect.
takes effect.
■
You can remove an authorization server only when no active TCP connection
for sending authorization packets is using it.
for sending authorization packets is using it.
Related command:
Example
# Configure the primary authorization server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authorization 10.163.155.13 49
reset hwtacacs statistics
Syntax
reset hwtacacs statistics { accounting | all | authentication | authorization }
View
User view
Parameter
accounting: Clears HWTACACS accounting statistics.
all: Clears all HWTACACS statistics.