3com MSR 20-20 참조 매뉴얼

C

HAPTER

 172: IPX C

ONFIGURATION

 C

OMMANDS

Use the ipx route load-balance-path command to specify the maximum 
number of equivalent routes to the same destination.

Use the undo ipx route load-balance-path command to restore the default.

The default is 1.

This number is the maximum active equivalent route number of the system. If a 
newly configured number is smaller than the previous, the system will change the 
excessive active routes to inactive routes.

# Specify the maximum equivalent route number to the same destination address 
as 30.

<Sysname> system-view

[Sysname] ipx route load-balance-path 30 

ipx route max-reserve-path paths

System view

paths: Maximum number of routes to the same destination, including both static 
and dynamic routes, in the range 1 to 255.

Use the ipx route max-reserve-path command to specify the maximum 
number of routes to the same destination.

Use the undo ipx route max-reserve-path command to restore the default.

By default, the value is 4.

When the route number to the same destination address exceeds the maximum 
value configured, the newly found dynamic routes will not be added into the 
routing table, but discarded directly. If the newly configured value is less than the 
original one, the excessive routes in the current routing table will not be deleted 
until they get aged out or are deleted manually.

# Specify the maximum number of routes to the same destination to 200.

<Sysname> system-view

[Sysname] ipx route max-reserve-path 200