3com MSR 20-20 참조 매뉴얼
2572
C
HAPTER
173: V
O
IP C
ONFIGURATION
C
OMMANDS
Parameter
send-dtmf milliseconds: Specifies a delay (in milliseconds) before the originating
side sends DTMF signals in the immediate start mode. The value ranges from 50 to
5,000.
side sends DTMF signals in the immediate start mode. The value ranges from 50 to
5,000.
Description
Use the delay send-dtmf command to configure a delay before the originating
side sends DTMF signals in the immediate start mode.
side sends DTMF signals in the immediate start mode.
Use the undo delay send-dtmf command to restore the default.
By default, the delay before the originating side sends DTMF signals in the
immediate start mode is 300 milliseconds.
immediate start mode is 300 milliseconds.
Related command:
Example
# Set the delay before the originating side sends DTMF signals in the immediate
start mode to 3,000 milliseconds.
start mode to 3,000 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1] delay send-dtmf 3000
delay send-wink
Syntax
delay send-wink milliseconds
undo delay send-wink
View
E&M voice subscriber line view
Parameter
send-wink milliseconds: Specifies an interval (in milliseconds) from when the
terminating side receives a seizure signal to when it sends a wink signal in the
wink start mode. The value ranges from 100 to 5,000.
terminating side receives a seizure signal to when it sends a wink signal in the
wink start mode. The value ranges from 100 to 5,000.
Description
Use the delay send-wink command to configure an interval from when the
terminating side receives a seizure signal to when it sends a wink signal in the
wink start mode.
terminating side receives a seizure signal to when it sends a wink signal in the
wink start mode.
Use the undo delay send-wink command to restore the default.
By default, the interval from when the terminating side receives a seizure signal to
when it sends a wink signal is 200 milliseconds in the wink start mode.
when it sends a wink signal is 200 milliseconds in the wink start mode.
Related command:
Example
# Set the interval from when the terminating side receives a seizure signal to when
it sends a wink signal in the wink start mode to 700 milliseconds.
it sends a wink signal in the wink start mode to 700 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0