3com MSR 20-20 참조 매뉴얼

# Set the dot match rule of number substitution rule list 20 to right-left.

<Sysname> system-view

[Sysname] voice-setup

[Sysname-voice] dial-program

[Sysname-voice-dial] number-substitute 20

[Sysname-voice-dial-substitute20] dot-match right-left 

first-rule rule-number

Voice number-substitute view

rule-number: Serial number of a number substitution rule (namely, the serial 
number of a number substitution rule configured by using the rule command), in 
the range of 0 to 31.

Use the first-rule to configure a preferred number substitution rule in the current 
number substitution rule list.

Use the undo first-rule command to remove the configured preferred number 
substitution rule.

By default, no preferred number substitution rule is configured.

In a voice call, the system first uses the rule defined by the first-rule command for 
number substitution. If this rule fails to apply or is not configured, it will try to 
apply all other rules in order until one or none of them applies.

# Specify rule 4 in number substitution list 20 as the preferred rule.

<Sysname> system-view

[Sysname] voice-setup

[Sysname-voice] dial-program

[Sysname-voice-dial] number-substitute 20

[Sysname-voice-dial-substitute20] rule 4 663 3

[Sysname-voice-dial-substitute20] first-rule 4 

max-call set-number max-number

undo max-call { set-number I all }

Voice dial program view

set-number: Number identifying a maximum-call-connection set, in the range of 1 
to 2,147,483,647. At most 256 maximum-call-connection sets can be configured.