3com MSR 20-20 참조 매뉴얼
175
E1
AND
T1 C
ONFIGURATION
C
OMMANDS
ani
Syntax
ani { all | ka }
undo ani
View
R2 CAS view
Parameter
all: Specifies the remote end to send the category of the calling party and calling
number.
number.
ka: Specifies the remote end to send only the category of the calling party.
Description
Use the ani command to enable the terminating point to request calling party
information (service category and calling number) from the originating point
during call connection.
information (service category and calling number) from the originating point
during call connection.
Use the undo ani command to disable the terminating point from requesting
calling party information from the originating point.
calling party information from the originating point.
By default, the terminating point does not request calling party information from
the originating point during call connection.
the originating point during call connection.
n
■
Configure the local end with this command to support automatic number
identification.
identification.
■
This command applies to R2 signaling only.
■
Normally the all keyword is configured. Use the ka keyword only when
required by the connected switch to prevent call failures.
required by the connected switch to prevent call failures.
Related command:
cas and ani-offset.
Example
# Request the remote office to send calling number category and calling number
during call connection.
during call connection.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] ani all