3com MSR 20-20 참조 매뉴얼
2648
C
HAPTER
175: E1
AND
T1 C
ONFIGURATION
C
OMMANDS
ani-offset
Syntax
ani-offset number
undo ani-offset
View
R2 CAS view
Parameter
number: Number of digits to be collected, in the range of 1 to10.
Description
Use the ani-offset command to configure the number of called number digits
that need to be collected prior to requesting calling party information.
that need to be collected prior to requesting calling party information.
Use the undo ani-offset command to restore the default value.
Before adequate digits are collected, the system will wait for the next digit until
the timer expires. During this period, the system does not request calling party
information. It does that only after adequate digits are collected.
the timer expires. During this period, the system does not request calling party
information. It does that only after adequate digits are collected.
By default, the number of digits to be collected before the calling party
information is 1.
information is 1.
This command applies to R2 signaling only.
Related command:
Example
# Start requesting calling number or caller identifier after receiving three digits.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] ani all
[Sysname-cas1/0:0] ani-offset 3
answer enable
Syntax
answer enable
undo answer enable
View
R2 CAS view
Parameter
None
Description
Use the answer enable command to configure the originating point to require
the terminating point to send answer signal. Only after receiving an answer signal
can the two parties begin to talk.
the terminating point to send answer signal. Only after receiving an answer signal
can the two parties begin to talk.
Use the undo answer enable command to restore the default.