3com MSR 20-20 참조 매뉴얼
2656
C
HAPTER
175: E1
AND
T1 C
ONFIGURATION
C
OMMANDS
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] final-callednum enable
force-metering enable
Syntax
force-metering enable
undo force-metering enable
View
R2 CAS view
Parameter
None
Description
Use the force-metering enable command to enable R2 metering signal
processing.
processing.
Use the undo force-metering enable command to disable R2 metering signal
processing.
processing.
By default, R2 metering signal processing is disabled.
This command applies to R2 signaling only.
When the terminating point supports metering signals, the system may send a
forced release signal instead of a clear-back signal to release the line. This is to
avoid collision between the clear-back signal sent by the called party and the
metering signal.
forced release signal instead of a clear-back signal to release the line. This is to
avoid collision between the clear-back signal sent by the called party and the
metering signal.
Example
# Enable R2 metering signal processing.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] force-metering enable
group-b enable
Syntax
group-b enable
undo group-b enable
View
R2 CAS view
Parameter
None