3com MSR 20-20 참조 매뉴얼
408
C
HAPTER
22: F
RAME
R
ELAY
C
ONFIGURATION
C
OMMANDS
Example
# Clear all the frame relay dynamic address maps.
<Sysname> reset fr inarp
reset fr pvc
Syntax
reset fr pvc interface serial interface-number [ dlci dlci-number ]
View
User view
Parameter
interface-number: Interface number.
dlci dlci-number: DLCI assigned to an FR interface. The dlci-number argument is in
the range 16 to 1007. Note that DLCI 0 through 15 and 1008 through 1023 are
reserved for special use and are thus unavailable.
the range 16 to 1007. Note that DLCI 0 through 15 and 1008 through 1023 are
reserved for special use and are thus unavailable.
Description
Use the reset fr pvc command to clear the statistics on a PVC.
Example
# Clear PVC statistics on Serial 2/0.
<Sysname> reset fr pvc interface serial 2/0
timer hold
Syntax
timer hold seconds
undo timer hold
View
Interface view
Parameter
seconds: Value of T391 parameter at DTE side, which ranges from 0 to 32767 in
seconds. 0 indicates that the LMI protocol is disabled.
seconds. 0 indicates that the LMI protocol is disabled.
Description
Use the timer hold command to configure T391 parameter at the DTE side.
Use the undo timer hold command to restore the default.
By default, the parameter is 10 seconds.
The parameter is a time variable that defines the interval of Status-Enquiry packet
sent by DTE.
sent by DTE.
Related command:
Example
# Configure that frame relay interface Serial 2/0 to operate in DTE mode, and set
the value of T391 parameter to 15 seconds.
the value of T391 parameter to 15 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr