3com MSR 20-20 참조 매뉴얼

C

HAPTER

 26: LAPB 

AND

 X.25 C

ONFIGURATION

 C

OMMANDS

# Set the restart timer on the X.25 interface Serial 2/0 to 120 seconds.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] x25 timer tx0 120 

x25 timer tx1 seconds

Interface view

seconds: Time of calling request (indication) sending timer in seconds, ranging 
from 0 to 1000.

Use the x25 timer tx1 command to set calling request (indication) sending timer 
for the DTE (or DCE).

Use the undo x25 timer tx1 command to restore the default.

By default, the timer time on a DTE is 200 seconds, and that on a DCE is 180 
seconds.

According to X.25, a timer should be started when the DTE sends a call request (or 
the DCE sends a call indication). If no peer acknowledgement is received after the 
timer timeout, the sending end will take some measures to guarantee the normal 
proceeding of the local procedure. This parameter specifies the time of this timer.

x25 timer tx0, x25 timer tx2, x25 timer tx3.

# Set calling request (indication) sending timer on the X.25 interface Serial2/0 to 
100 seconds.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] x25 timer tx1 100 

x25 timer tx2 seconds

Interface view

seconds: Reset request (indication) timer in seconds, ranging from 1 to 1000.