3com MSR 20-20 참조 매뉴얼

You can configure the following parameters on the virtual-template:

■

Local IP address and the IP address (or IP address pool) assigned to the peer

■

PPP working parameter

ppp mp and ppp mp max-bind.

# Specify the VT interface that corresponds to user 1 as 1, and configure the IP 
address of the VT as 202.38.60.1.

<Sysname> system-view

[Sysname] ppp mp user user1 bind virtual-template 1

[Sysname] interface virtual-template 1

[Sysname-Virtual-Template1] ip address 202.38.60.1 255.255.255.0 

ppp mp virtual-template number

Interface view

number: Specifies the VT interface number to be bound on the interface, in the 
range 0 to 1023.

Use the ppp mp virtual-template command to configure the VT interface 
number to be bound on the interface, enabling the interface to work in MP mode.

Use the undo ppp mp command to remove MP binding of the interface, making 
the interface to work in PPP mode.

By default, MP binding on the interface is disabled, and the interface works in PPP 
mode.

This command specifies the VT interface number to be bound on the interface. In 
configuring MP binding on the interface configured with this command, you 
needs not configure PAP or CHAP authentication.

Two or more interfaces with the same virtual template number is bound directly 
together. Moreover, once you used this command on an interface, you cannot use 
the ppp mp command on the same interface, and vice versa.

# Configure interface serial 1/0 encapsulated with PPP to work in MP mode, with 
the VT interface being Virtual-Template1

<Sysname> system-view

[Sysname] interface serial 1/0

[Sysname-Serial1/0] ppp mp virtual-template 1