3com MSR 20-20 참조 매뉴얼
883
display ipv6 interface tunnel
Syntax
display ipv6 interface tunnel number
View
Any view
Parameter
number: Tunnel interface number.
Description
Use the display ipv6 interface tunnel command to display related IPv6
information of a specified tunnel interface, including link state, IPv6 protocol state,
and IPv6 address.
information of a specified tunnel interface, including link state, IPv6 protocol state,
and IPv6 address.
Example
# Display information of the interface tunnel 0.
<Sysname> display ipv6 interface tunnel 0
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::101:101
Global unicast address(es):
2002:101:101::1, subnet is 2002::/16
Joined group address(es):
FF02::1:FF01:101
FF02::1:FF00:1
FF02::2
FF02::1
MTU is 1500 bytes
aggregation ID
Link aggregation group ID referenced by a tunnel. If
the device supports link aggregation groups, the link
aggregation group ID configured in tunnel interface
view is displayed. If device does not support,
“aggregation ID not set” is displayed.
the device supports link aggregation groups, the link
aggregation group ID configured in tunnel interface
view is displayed. If device does not support,
“aggregation ID not set” is displayed.
Tunnel source
Source address of a tunnel.
destination
Destination address of a tunnel.
Tunnel keepalive disable
Disables the keepalive function of the GRE so as not to
detect the tunnel interface state.
detect the tunnel interface state.
Tunnel protocol/transport
Tunnel protocol and transport protocol.
GRE key disabled
No key is configured for the GRE tunnel interface.
Checksumming of GRE packets
disabled
disabled
Disables the GRE packet checksum function.
Last 300 seconds input
Number of bytes and packets input per second in the
last five minutes.
last five minutes.
Last 300 seconds output
Number of bytes and packets output per second in the
last five minutes.
last five minutes.
packets input
Total number of input packets.
input error
Number of error packets among all input packets.
packets output
Total number of output packets.
output error
Number of error packets in all output packets
Table 189 Description on fields of the display interface tunnel command
Field Description