3com MSR 20-20 참조 매뉴얼
884
C
HAPTER
68: T
UNNELING
C
ONFIGURATION
C
OMMANDS
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
encapsulation-limit
Syntax
encapsulation-limit [ number ]
undo encapsulation-limit
View
Tunnel interface view
Parameter
number: Number of nested encapsulations in a tunnel, in the range of 1 to 10.
The default value is 4.
The default value is 4.
Description
Use the encapsulation-limit command to configure the maximum number of
nested encapsulations of a packet.
nested encapsulations of a packet.
Use the undo encapsulation-limit command to remove the encapsulation
limit.
limit.
The encapsulation limit is only applicable to the IPv6 over IPv6 tunnel.
Example
# Configure the maximum number of nested encapsulations in a tunnel to 3.
<Sysname> system-view
[Sysname] interface tunnel 2
[Sysname-Tunnel2] tunnel-protocol ipv6-ipv6
[Sysname-Tunnel2] encapsulation-limit 3
interface tunnel
Syntax
interface tunnel number
Table 190 Description on fields of the display interface tunnel command
Field Description
Tunnel0 current state: UP
The physical layer of the tunnel interface is reachable.
Line protocol current state: UP
The link layer of the tunnel interface is reachable.
IPv6 is enabled
Enables IPv6 on a tunnel interface
link-local address
Link-local address of a tunnel interface
Global unicast address(es)
Aggregatable global unicast address of a tunnel interface.
Joined group address(es)
Multicast address of a tunnel interface.
MTU is 1500 bytes
Size of the MTU in a tunnel. The MTU in this example is
1,500 bytes.
1,500 bytes.
ND reachable time
Neighbor reachable time
ND retransmit interval
Interval for retransmitting a neighbor discovery message.
Hosts use stateless autoconfig for
addresses
addresses
Hosts use the stateless auto-configuration mode to
acquire IPv6 addresses.
acquire IPv6 addresses.