3com MSR 20-20 사용자 설명서
MIM-1AE3 Module
107
Interface Optical Fiber
MIM-1AMM uses multi-mode optical cable and MIM-1ASM/MIM-1ASL uses
single-mode optical cable. As all these three modules adopt SC optical fiber
connector, the connector of the connection cable should also be SC connector.
The external optical cable suite provides you with optical cables of different
lengths.
single-mode optical cable. As all these three modules adopt SC optical fiber
connector, the connector of the connection cable should also be SC connector.
The external optical cable suite provides you with optical cables of different
lengths.
w
WARNING: Laser danger! Do not directly stare at the optical fiber connector
connected with the laser, in case of the injury that may cause to your eyes.
connected with the laser, in case of the injury that may cause to your eyes.
c
CAUTION:
■
MIM-1ASL module adopts long-haul fiber interface, requiring a transmission at
least longer than 25 km (15.5 in.). If the transmission distance is lower than
25km, the interface will be unable to receive signals.
least longer than 25 km (15.5 in.). If the transmission distance is lower than
25km, the interface will be unable to receive signals.
■
MIM-1AMM module should be connected with multi-mode optical fibers
whereas MIM-1ASM/MIM-1ASL modules should be connected with
single-mode optical fibers.
whereas MIM-1ASM/MIM-1ASL modules should be connected with
single-mode optical fibers.
n
These cables are optional. Please order them when purchasing
MIM-1AMM/MIM-1ASM/MIM-1ASL modules; by default, they are not provided.
MIM-1AMM/MIM-1ASM/MIM-1ASL modules; by default, they are not provided.
MIM-1AE3 Module
Introduction
1-port 34.368 Mbps ATM-E3 interface module (MIM-1AE3) supports:
■
Two ATM cell mapping modes: ATM Direct Mapping (ADM) and Physical Layer
Convergence Protocol (PLCP);
Convergence Protocol (PLCP);
■
Scrambling in data transmission;
■
Both line clock (when working as DTE interface) and internal clock (when
working as DCE interface);
working as DCE interface);
■
Four types of test measures, that is, local cell loopback, local payload loopback,
remote payload loopback, and remote line loopback.
remote payload loopback, and remote line loopback.
n
You are allowed to equip an H3C Series Router with MIM-AE3 modules to its full
capacity. Yet, you are recommended to install only one MIM-AE3 module on it,
whatever its model is, to ensure the performance of some key services.
capacity. Yet, you are recommended to install only one MIM-AE3 module on it,
whatever its model is, to ensure the performance of some key services.
Interface Attributes
The interface attributes of MIM-1AE3 are given in the following table:
Table 67 Interface attributes of MIM-1AE3
Attribute 1AE3
module
Connector SMB
Connector number
2
Interface standard
G.703, G.751, G.832, G.823
Interface rate
34.368 Mbps
Cable
E3/T3 cable (75-ohm coaxial cables)
Supported service
ATM Traffic CBR, rt_VBR, nrt_VBR, UBR