3com MSR 20-20 사용자 설명서
MIM-1AT3 Module
109
Step 2: Connect the SMB connector of another E3/T3 cable to the Rx port of
MIM-1AE3 module and another end to the Tx port on the device to be connected;
MIM-1AE3 module and another end to the Tx port on the device to be connected;
Step 3: Check the behavior of the LINK LED on the MIM-1AE3 panel. It is OFF
when fault has occurred on the link and signal is out of synchronization. In this
case, please check the link.
when fault has occurred on the link and signal is out of synchronization. In this
case, please check the link.
MIM-1AT3 Module
Introduction
1-port 44.736 Mbps ATM-T3 interface module (MIM-1AT3) supports:
■
Two ATM cell mapping modes: ADM and PLCP;
■
Scrambling in data transmission;
■
Both line clock (when working as DTE interface) and internal clock (when
working as DCE interface);
working as DCE interface);
■
Four types of test measures, i.e., local cell loopback, local payload loopback,
remote payload loopback, and remote line loopback.
remote payload loopback, and remote line loopback.
n
You are allowed to equip an H3C Series Router with MIM-AT3 modules to its full
capacity. Yet, you are recommended to install only one MIM-AT3 module on it,
whatever its model is, to ensure the performance of some key services.
capacity. Yet, you are recommended to install only one MIM-AT3 module on it,
whatever its model is, to ensure the performance of some key services.
Interface Attributes
The interface attributes of MIM-1AT3 are given in the following table:
n
In the supported services described in the above table, CBR represents Constant
Bit Rate, rt_VBR represents Variable Bit Rate-Real Time, nrt_VBR represents
Variable Bit Rate-Non Real Time, and UBR represents Unspecified Bit Rate.
Bit Rate, rt_VBR represents Variable Bit Rate-Real Time, nrt_VBR represents
Variable Bit Rate-Non Real Time, and UBR represents Unspecified Bit Rate.
Interface LEDs
MIM-1AT3 panel is shown in the following figure:
Figure 122 MIM-1AT3 panel
The following table describes the LEDs on the MIM-1AT3 panel:
Table 69 Interface attributes of MIM-1AT3 module
Attribute 1AT3
Module
Connector SMB
Connector number
2
Interface standard
G.703, G.704, G.823
Interface rate
44.736 Mbps
Cable
E3/T3 cable (75-ohm coaxial cables)
Supported service
ATM Traffic CBR, rt_VBR, nrt_VBR, UBR