Xerox 6180MFP 사용자 가이드

Cannot scan to 
computer

Is the printer connected to the network?

Connect the printer to the network for Computer (Network) and Server 
(FTP) scanning. If using the Express Scan Manager, then connect the 
printer via USB.

Is the user name and password set correctly?

Verify that the user name and password are correctly defined in the 
Address Book.

is the correct folder name specified.

Check that the shared folder name and computer IP address are correctly 
defined in the Address Book.

Cannot send or receive 
fax

Is the printer connected to an analog phone outlet?

If not, connect the printer to a known good analog phone outlet.

Are the fax parameters configured properly?

Verify that the fax parameters have been set correctly.

Print job sent but the 
light of the Ready 
indicator is not blinking 
or on

Is the interface cable disconnected?

Turn off the power and check the connection of the interface cable.

Is the protocol configured?

Check the port status of the interface. Make sure the protocol settings are 
correctly configured in CentreWare IS. See the Online Help for 
CentreWare IS.

Is the computer environment correctly set up?

Check the computer environment, such as the print driver. See 

Error indicator is on

Is there an error message displayed on the control panel?

Check the displayed message and correct the error.

Error indicator is 
blinking

An error that you cannot correct by yourself has occurred.

Record the displayed error message or error code, turn off the power, pull 
out the power plug from the outlet. Refer to the Xerox Support website, 

.

Light of the Ready 
indicator is on and 
blinking but there is no 
print output

There are jobs remaining in the printer.

Cancel printing or force the remaining data to be printed.

To forcibly print the job, press the OK button. To cancel the job, press the 
Stop button.

Top section of printed 
document is missing. 
The top and side 
margins are incorrect.

Are the paper tray guides in the correct positions?

Set the length guide and the width guides to the correct positions. See 

Check that the paper size on the print driver or the control panel is correctly 
set.

See the Online Help for the print driver. See 

Check that the margin setting is correct on the print driver. (PCL only)

See the Online Help for the print driver.