Infocus LP770 설치 설명서
S t e p 5
S t e p 5
Raise the projector with the mounting bracket and slip through
the hinge pin slot openings on the bracket into the base box.
Loosely install the two hinge pin bolts, spacers and washers and
the angle locking bolts. Adjust the angle and lock it. Then tighten
the hinge pin bolts. See Figure 3
the hinge pin slot openings on the bracket into the base box.
Loosely install the two hinge pin bolts, spacers and washers and
the angle locking bolts. Adjust the angle and lock it. Then tighten
the hinge pin bolts. See Figure 3
The ceiling should be capable of supporting a weight of
at least five (5) times the projector(s) or
monitor(s)weight. If it cannot, the ceiling must be
reinforced. Proper installation procedure by qualified
personnel as outlined in the installation instructions
must be adhered to. Failure to do so could result in
serious personal injury.
DESCRIPTION/HARDWARE
DESCRIPTION/HARDWARE
A. Projector
B. 4mmx20mm Phillip Head Screws (2ea.)
C. 4mm Quick Release Sleeves (2ea.)
D. Front Feet (Raise 3/8” from the projector)
E. 4mmx10mm Knurl Knobs (2ea.)
F.
B. 4mmx20mm Phillip Head Screws (2ea.)
C. 4mm Quick Release Sleeves (2ea.)
D. Front Feet (Raise 3/8” from the projector)
E. 4mmx10mm Knurl Knobs (2ea.)
F.
Projector Mount (1ea.)
G. Ceiling Structure
H. Conical Spacer (2ea.)
I.
H. Conical Spacer (2ea.)
I.
6mm Flat Washer (2ea.)
J.
6mmx12mm Hinge Pin bolts (2ea.)
K. 6mmx12mm Angle Locking Bolts (2ea.)
L. PBB-12L Base Box
L. PBB-12L Base Box
M.
SP-LTMT-EXT
27700B S.W. Parkway Ave.
Wilsonville, Oregon 97070-9215
Phone 1-800-294-6400 Fax
www.infocus.com