Epson 830p 매뉴얼

Before using the EasyManagement software to manage your 
projector(s), you have to connect each projector you want to monitor 
to your network and configure it with an appropriate IP address. You 
can connect and configure the projector using the network port.

Follow these steps to connect and configure the projector for your 
network.

1. Connect the projector to your network using a commercially 

available 100baseTX or 10baseT network cable.

2. Turn on the projector (see page 18). 

3. Press the 

Menu

 button on the remote control and select 

Network

 

from the 

Extended

 menu.

4. If your network assigns addresses automatically, turn on 

DHCP

.

If your network does not assign addresses automatically, turn off 

DHCP

 and enter the projector’s 

IP Address

, 

Subnet Mask

, and 

Gateway Address

, as needed. 

■

To enter numbers using the remote control, press the 

Num

 

button until it lights, then use the number keypad shown 
below. 

SNMP