Epson Сетевое руководство 네트워크 가이드
Note:
For Mac OS X 10.5, select Ethernet as the connecting method on the Network control panel,
select the method to assign the IP address from the Configure menu, and then assign the IP address.
For Mac OS X 10.5, select Ethernet as the connecting method on the Network control panel,
select the method to assign the IP address from the Configure menu, and then assign the IP address.
3. Select Built-in Ethernet from the Show pull down menu.
4. Assign an IP address and other settings if necessary.
5. Click the Apply Now button to save any changes.
Setting Up the Network Interface
Connecting the Network Interface to the Network
Follow the instructions below to connect the network interface to the network.
1. Make sure that your printer is turned off.
2. Connect one end of the network cable to the RJ-45 connector on the network interface, and the
other end to the network.
c
Caution:
❏ You must use the following shielded twisted-pair cable to connect the network interface
❏ You must use the following shielded twisted-pair cable to connect the network interface
to a network.
-- Category-5 or higher for the 10Base-T or 100Base-TX connection
-- Category-5e or higher for the 1000Base-T connection
❏ Do not connect the network interface and the computer directly. Be sure to use a HUB
to connect the network interface to the network.
Note:
You can use both 10Base-T and 100Base-TX. (On some models, 1000Base-T is also supported.)
When you print a lot of data, we recommend you use a higher-speed with light network traffic.
You can use both 10Base-T and 100Base-TX. (On some models, 1000Base-T is also supported.)
When you print a lot of data, we recommend you use a higher-speed with light network traffic.
3. Turn on your printer. After the status lights go off, print a network status sheet.
EPSON Network Guide
How To 36