Canon REALiS WUX6010 D Pro AV 매뉴얼

195

O

ther Information

T

roub
lesho

o

ting

■ The Projector Cannot Join the Network

The lamp has ruptured 
(or there is a lamp 
malfunction).

If the lamp has ruptured, follow the instructions in 
“Precautions when replacing lamps that stop 
working” (

The operating 
environment is 
inappropriate.

Check whether the operating temperature is between 
0°C (32°F) and 40°C (104°F). (

Projector settings must be adjusted when using the 
projector at altitudes of 2,300 m (7,545.8') or higher. 
In the [Install settings] menu, set [Fan mode] under 
[Professional settings] to [High altitude]. (

)

The LAN cable (shielded 
twisted pair) is not 
connected correctly.

Check whether the LAN cable (shielded twisted pair) 
is connected to the projector correctly. (

[HDBaseT] was changed 
from [On] to [Off] while 
[Communication 
settings] > [Wired 
network] was set to 
[HDBaseT].

Configure the [HDBaseT] setting again as follows. 
(

1. Change the [HDBaseT] setting from [Off] to [On] 

again.

2. Change the wired network setting from [LAN port] 

to [HDBaseT].

3. Following the instructions shown, press the 

POWER button to enter standby mode 
temporarily.

4. After at least five minutes, press the POWER 

button again.

The projector has not 
been on long enough 
(less than about 40 
seconds).

Network connections are not available until about 40 
seconds after startup. Wait at least 40 seconds, and 
then try to connect again. (

)