Netgear JWNR2000v2 - Wireless-N 300 Router 사용자 설명서
Chapter 6. Advanced Settings
|
85
NETGEAR N300 Wireless Router JWNR2000v2 User Manual
2.
Log into the router base unit, under the Advanced heading, select
Wireless Repeating
Function to display the Wireless Repeating Function screen.
3.
Select the
Enable Wireless Repeating Function check box and the Wireless Base
Station radio button.
4.
Enter the MAC address for the repeater units.
5.
Click
Apply to save your changes.
Set Up a Repeater Unit
Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the
wireless connection to the base station.
wireless connection to the base station.
Note:
If you are using the JWNR2000v2 base station with a
non-NETGEAR router as the repeater, you might need to change
additional configuration settings. In particular, you should disable the
DHCP server function on the wireless repeater
additional configuration settings. In particular, you should disable the
DHCP server function on the wireless repeater
access point.
To configure a JWNR2000v2 router as a repeater unit:
1.
If you are using the same model of router for both the base station and repeaters, you
must change the LAN IP address for each repeater to a different IP address in the same
subnet (see
69).
Note:
Failing to change the LAN IP address will cause an IP address
conflict in the network because the factory default LAN IP is the
same for both units.
same for both units.