Netgear WC7500 - ProSAFE® Wireless Controller 사용자 설명서

To make sure that all the access points are listed, review the discovery results.

The effectiveness of the discovery process depends in part on how the access points on 
your LAN are set up. If each access point is configured with a unique IP address and is 
running current firmware, discovery is simple. 

If the discovery results are not what you expect, check the following:

Access points that the wireless controller already manages are not in the discovery 

list.

To view the Managed AP List, select Access Point > Managed AP List.

The access points might be in a different IP network. 

For information about how to discover access points in a different subnet, see 

Access points that are in factory default mode but across a router are not detected. 

For information about how to discover access points across a router, see 

Make sure that a DHCP server is available in the network or on the wireless 
controller. 

For information about the wireless controller’s DHCP server, see 

To run the discovery process again, click the Restart button.

To designate an access point as a remote access point, from the Site menu, select 
Remote.

By default, all discovered access points are designated as Local. The Remote and 
Local designations are for organization only.

The wireless controller cannot discover remote access points over a 
site-to-site VPN connection or behind a remote NAT router without a 
VPN connection. To use an access point as a remote access point 
over a site-to-site VPN connection or behind a remote NAT router 
without a VPN connection, you must preprovision the access point and 
send it to the remote site for installation. For remote access points, the 
maximin WAN delay period is 100 millisecond.

Either select individual access points to be added to the managed list or select all access 
points to be added to the managed list:

Select individual check boxes for discovered access points that you want to add to 
the managed list.

Select the check box in the upper right of the table heading to add all discovered 
access points to the managed list.