Netgear WNDAP350 – ProSAFE Dual Band Wireless-N Access Point 사용자 설명서

DHCP Client Support. DHCP provides a dynamic IP address to PCs and other devices 
upon request. The WNDAP350 can act as a client and obtain information from your 
DHCP server; it can also act as a DHCP server and provide network information for 
wireless clients.

SNMP Support. Support for Simple Network Management Protocol (SNMP) 
Management Information Base (MIB) management.

802.1Q VLAN (Virtual LAN) Support. A network of computers that behave as if they are 
connected to the same network even though they actually may be physically located on 
different segments of a LAN. VLANs are configured through software rather than 
hardware, which makes them extremely flexible. VLANs are very useful for user/host 
management, bandwidth allocation and resource optimization. 

The WNDAP350 provides solid functionality, including the following features:

Dual Band Concurrent. The wireless access point can operate in both the 2.4 GHz band 
and the 5 GHz band concurrently.

The choice of band(s) is reflected in the protocol standard supported, as well as the 
administration screens displayed to you. 

Multiple operating modes. The wireless access point can operate in the following 
modes:

Wireless Access Point. Operates as a standard 802.11a/an or 11b/bg/ng access 
point.

Point-to-Point Bridge. In this mode, the WNDAP350 only communicates with 
another bridge-mode wireless access point (with or without clients). Network 
authentication should be used to protect this communication. 

Point-to-Multi-Point Bridge. Select this only if this WNDAP350 is the Master for a 
group of bridge-mode wireless access points. The other bridge-mode wireless access 
points send all traffic to this Master, and do not communicate directly with each other. 
Network Authentication should be used to protect this traffic. 

Hotspot Settings. You can allow the first HTTP (TCP, port 80) request, on client 
association, to be captured and redirected to the URL you specify.

Upgradeable Firmware. Firmware is stored in a flash memory and can be upgraded 
easily, using only your Web browser, and can be upgraded remotely. In addition to using 
Web browser to do so, command-line interface and SNMP can also be used.

Rogue AP detection. The Rogue AP detection feature shows a list of unknown APs to 
the administrator.

Access Control. The Access Control MAC address filtering feature can ensure that only 
trusted wireless stations can use the WNDAP350 to gain access to your LAN.

Security Profiles. When using multiple BSSIDs, you can configure unique security 
settings (encryption, SSID, etc.) for each BSSID.