Netgear WN604 - Wireless-N 150 Access Point 사용자 설명서

By default, the access point is set with the DHCP client disabled. If 

your network uses dynamic IP addresses, you have to change this 
setting. To connect to the access point after the DHCP server on 
your network assigns it a new IP address, enter the access point 
name into your web browser. The default access point name is 
netgearxxxxxx, where xxxxxx represents the last 6 bytes of the MAC 
address. The default name is printed on the bottom label of the 
access point.

Connect the power adapter to the wireless access point and plug the power adapter in to a 
power outlet. The Power, LAN, and WiFi LEDs should light up. 

Verify Wireless Connectivity

Using a computer with an 802.11b/bg/ng wireless adapter with the correct wireless settings 
needed to connect to the access point (SSID, WEP/WPA, MAC ACL, etc.), verify connectivity 
by using a browser such as Mozilla Firefox or Internet Explorer to browse the Internet, or 
check for file and printer access on your network.

The default SSID for the 802.11b/bg/ng wireless mode is NETGEAR-11g. The SSID of any 
wireless access adapters has to match the SSID configured in the access point. If they do not 
match, no wireless connection is made. 

If you are unable to connect, see 

.

Wireless Equipment Placement and Range Guidelines

The operating distance or range of your wireless connection can vary significantly based on 
the physical placement of the access point. The latency, data throughput performance, and 
notebook power consumption of wireless adapters also vary depending on your configuration 
choices.

Failure to follow these guidelines can result in significant 

performance degradation or inability to wirelessly connect to the 
WN604. For complete performance specifications, see