Netgear WNAP320 - ProSAFE Wireless-N Access Point 참조 매뉴얼

Install and Configure the Wireless Access Point

Before installing the wireless access point, make sure that your Ethernet network is up and 
working. You will be connecting the wireless access point to the Ethernet network. Then 
computers with 802.11b/g or 802.11n wireless adapters will be able to communicate with the 
Ethernet network.

In order for this to work correctly, verify that you have met all of the system requirements, 
shown in 

Install and configure your wireless access point in the order of the following sections:

1.  Connect the Wireless Access Point to Computer 

on this page.

2.  Log In to the Wireless Access Point on page 18

3.  Configure Basic General System Settings and Time Settings on page 19

4.  Configure IP Settings and Optional DHCP Server Settings on page 21

5.  Configure Basic Wireless Settings on page 23

.

Connect the Wireless Access Point to Computer

Before you place the wireless access point in an elevated position that is 

difficult to reach, first set up and test the wireless access point to verify 
wireless network connectivity.

Unpack the box and verify the contents.

Prepare a computer with an Ethernet adapter. If this computer is already part of your 
network, record its TCP/IP configuration settings. Configure the computer with a static IP 
address of 192.168.0.210 and 255.255.255.0 as the subnet mask.

Connect an Ethernet cable from the wireless access point to the computer (point A in the 
following figure).

Securely insert the other end of the cable into the wireless access point’s Ethernet port 
(point B in the following figure).

.