Netgear WNAP320 - ProSAFE Wireless-N Access Point 참조 매뉴얼
Chapter 5. Advanced Configuration
|
76
5
5.
Advanced Configuration
This chapter describes how to configure the advanced features of your ProSAFE Wireless-N
Access Point WNAP320. The chapter includes the following sections:
Spanning Tree Protocol and 802.1Q VLAN
The advanced General system settings screen allows you to enable the Spanning Tree
Protocol (STP) and configure the VLANs.
Protocol (STP) and configure the VLANs.
STP provides network traffic optimization in locations where multiple wireless access points
are active.
are active.
The 802.1Q VLAN protocol on the wireless access point logically separates traffic on the
same physical network:
same physical network:
•
Untagged VLAN. When the wireless access point sends frames that are associated with
the untagged VLAN from its Ethernet interface, those frames are untagged. When the
wireless access point receives untagged frames over its Ethernet interface, those frames
are assigned to the untagged VLAN.
wireless access point receives untagged frames over its Ethernet interface, those frames
are assigned to the untagged VLAN.
Note:
Select the Untagged VLAN check box only if the hubs and switches
on your LAN support the 802.1Q VLAN protocol. Likewise, change
the untagged VLAN value only if the hubs and switches on your LAN
support the 802.1Q VLAN protocol. Selecting the Untagged VLAN
check box or changing the untagged VLAN value will result in a loss
of IP connectivity if the hubs and switches on your LAN have not yet
been configured with the corresponding VLAN.
the untagged VLAN value only if the hubs and switches on your LAN
support the 802.1Q VLAN protocol. Selecting the Untagged VLAN
check box or changing the untagged VLAN value will result in a loss
of IP connectivity if the hubs and switches on your LAN have not yet
been configured with the corresponding VLAN.