Netgear GS752TXS - Stackable Smart Gigabit Ethernet Switch 관리자 가이드
155
5
5.
Configuring Routing
The GS752TXS and GS728TXS Smart Switches supports IP routing. Use the menus under
the Routing tab to manage routing on the system.
the Routing tab to manage routing on the system.
When a packet enters the switch, the destination MAC address is checked to see if it
matches any of the configured routing interfaces. If it does, then the switch searches the host
table for a matching destination IP address. If an entry is found, then the packet is routed to
the host. If there is no matching entry, then the switch performs a longest prefix match on the
destination IP address. If an entry is found, then the packet is routed to the next hop. If there
is no match, then the packet is routed to the next hop specified in the default route. If there is
no default route configured, then the packet is passed to the software to be handled
appropriately.
matches any of the configured routing interfaces. If it does, then the switch searches the host
table for a matching destination IP address. If an entry is found, then the packet is routed to
the host. If there is no matching entry, then the switch performs a longest prefix match on the
destination IP address. If an entry is found, then the packet is routed to the next hop. If there
is no match, then the packet is routed to the next hop specified in the default route. If there is
no default route configured, then the packet is passed to the software to be handled
appropriately.
The routing table can have entries added either statically by the administrator or dynamically
via a routing protocol. The host table can have entries added either statically by the
administrator or dynamically via ARP.
via a routing protocol. The host table can have entries added either statically by the
administrator or dynamically via ARP.
This chapter contains the following sections.
•
•
•
•
•
Configuring IP Settings
To configure and display IP routing data, see the following sections:
•
•
•