Netgear S3300-28X (GS728TX) - ProSAFE S3300 Smart Switch Series 하드웨어 매뉴얼
Installation
27
S3300 Smart Switch
Step 3: Check the Installation
Before you apply power to the smart switch, perform the steps that are described in this
section.
section.
To check the installation:
1.
Inspect the equipment thoroughly.
2.
Verify that all cables are installed correctly.
3.
Check cable routing to make sure that cables are not damaged or creating a safety hazard.
4.
Ensure that all equipment is mounted properly and securely.
Step 4: Connect Devices to the Switch
The following procedure describes how to connect computers to the smart switch’s RJ-45
ports. The smart switch supports Auto Uplink technology, which allows you attach devices
using either straight-through or crossover cables.
ports. The smart switch supports Auto Uplink technology, which allows you attach devices
using either straight-through or crossover cables.
The following figure shows model S3300-28X-PoE+. However, the other S3300 models are
connected in the same manner.
connected in the same manner.
Figure 12. Connecting devices to the smart switch
Note:
Ethernet specifications limit the cable length between the smart
switch and the attached device to 100 meters (328 feet).
switch and the attached device to 100 meters (328 feet).
To connect devices to the smart switch:
Using a Category 5 (Cat 5) unshielded twisted-pair (UTP) cable terminated with an RJ-45
connector, connect each computer to an RJ-45 network port on the smart switch front panel.
connector, connect each computer to an RJ-45 network port on the smart switch front panel.