Netgear S3300-28X (GS728TX) - ProSAFE S3300 Smart Switch Series 관리자 가이드

To enable remote management of the switch through a web browser or SNMP, you must 
connect the switch to the network and configure it with network information (an IP address, 
subnet mask, and default gateway). The switch has a default IP address of 192.168.0.239 
and a default subnet mask of 255.255.255.0. 

To change the default network information on the switch, use one of the following three 
methods:

Dynamic assignment through DHCP. DHCP is enabled by default on the switch. If you 
connect the switch to a network with a DHCP server, the switch obtains its network 
information automatically. You can use the Smart Control Center to discover the 
automatically assigned network information. For more information, see 

Static assignment through the Smart Control Center. If you connect the switch to a 
network that does not have a DHCP server, you can use the Smart Control Center to 
assign a static IP address, subnet mask, and default gateway. For more information, see 

Static assignment by connecting from a local host. If you do not want to use the 
Smart Control Center to assign a static address, you can connect to the switch from a 
host (administrative system) in the 192.168.0.0/24 network and change the settings by 
using the web management interface on the switch. For information about how to set the 
IP address on the administrative system so it is in the same subnet as the default IP 
address of the switch, see 

16.