Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서
158
|
Chapter 6. LLDP
NETGEAR 8800 User Manual
Note:
See the NETGEAR 8800 Chassis Switch CLI Manual for complete
information on configuring LLDP using the CLI.
lists the TLVs that the switch can receive, but not transmit. To receive any of these
TLVs, the port must be enabled for LLDP. After you enable LLDP receiving on the switch, all
TLVs are received (even if the LLDP MED capabilities TLV is not enabled). To display these
received messages, use the
TLVs are received (even if the LLDP MED capabilities TLV is not enabled). To display these
received messages, use the
show lldp neighbor detailed
CLI command.
Mandatory TLVs
This section describes the following mandatory TLVs, which are automatically enabled after
you enable LLDP on a port:
you enable LLDP on a port:
Location ID
X
MED TLVs transmit only
after detecting a neighbor
transmitting MED TLVs
after detecting a neighbor
transmitting MED TLVs
Extended power via MDI
X
Can be enabled only on a
PoE-capable port
PoE-capable port
MED TLVs transmit only
after detecting a neighbor
transmitting MED TLVs
after detecting a neighbor
transmitting MED TLVs
End-of-LLDP PDU
X
Mandatory TLV
Table 19. Available TLVs for Reception
Name
Type
Comments
Hardware revision
MED
Firmware revision
MED
Software revision
MED
Serial number
MED
Manufacturer name
MED
Model name
MED
Asset ID
MED
Table 18. Available TLVs for Transmission (Continued)
Name
Included by
default
default
User
configurable
configurable
Repeatable
Comments