Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서

System health check errors are reported to the syslog. If you see an error, contact NETGEAR 
Technical Support.

Enabling Diagnostic Packets on NETGEAR 8800 Switches

To enable diagnostic packets, use the following command:

enable sys-health-check slot <slot>

 

By default, the system health checker tests the data link or the 10 Gbps links every 5 seconds 
for the specified slot.

Enabling backplane diagnostic packets increases CPU utilization 

and competes with network traffic for resources. 

Configuring Diagnostic Packets on the Switch

To configure the frequency of sending backplane diagnostic packets, use the following 
command:

configure sys-health-check interval <interval>

NETGEAR does not recommend configuring an interval of less than 

the default interval. Doing so can cause excessive CPU utilization. 

Disabling Diagnostic Packets on the Switch

To disable diagnostic packets, use the following command:

disable sys-health-check slot <slot>

 

By default, the system health checker discontinues sending backplane diagnostic packets to 
the specified slot. Only polling is enabled.

Displaying the System Health Check Setting

To display the system health check setting, including polling and how XCM8800 software 
handles faults on the switch, use the following command: 

show switch

As previously described, polling is always enabled on the switch. 

The system health check setting, displayed as 

SysHealth check

, shows the polling setting 

and how XCM8800 handles faults. The polling setting appears as Enabled, and the fault